Skip to main content

AppliancesExabeam Appliance Setup Guide

Table of Contents

Connect the Exabeam Appliance Cabling

You must connect your appliance cables to the proper ports in order to start configuration.

Before installing an operating system image and Exabeam software onto your appliance, ensure your appliance is connected to your network.

  1. Connect an Ethernet cable to the RJ45 port labeled LAN1 on the back of the appliance.

  2. Connect the system to a monitor and keyboard for the initial configuration.

    After the configuration is completed, you can detach the monitor and keyboard.

    ex2003 ex4003 cabling

    EX2003 and EX4003 rear view

  3. Plug in both power cables to uninterrupted power supply (UPS) or conditioned power sources, ideally originating from different power circuits for each cable.

  4. Power up the host to start the boot process.